You'll need at least 512MB of RAM and i686 (Pentium III with PAE
support) CPU to boot it. There are 32bit and 64bit kernels.

If you want to run it in VirtualBOX (enable PAE) or VMWare, increase
the Base Memory to 1024. With QEMU using KVM, pass 'noexec=off' to
the kernel.

Please inform me if RIP is working or not!
Any suggestions are appreciated!

Use this Windows USB installer to put RIP on a USB drive.
Choose "RIP Linux" from its menu, then browse to where
RIPLinuX-13.7.iso is on your hard drive etc. It should
work with any ISO below, but your USB flash drive should
be at least 256MB and FAT16 or FAT32 formatted.

Other methods for putting RIP on a USB flash drive are
described in the USB readme below.

Verify the ISO under Linux or Windows.
md5sum -c RIPLinuX-13.7.md5 "It should say OK!"

This is a GRUB2 X version. If the one above doesn't boot, try this.
It only boots from CD/DVD!

This is a PXE network X version.
unzip -L RIPLinuX-13.7.PXE.zip "Extract under Linux!"

Read the USB readme for instructions on how to install RIP
on a USB flash drive.

Read the mkextlin readme for instructions on how to install
the Linux system on a USB flash drive partition. You can
then boot and use it the same as if it was installed to a
Linux Ext2/3/4 or Btrfs formatted partition on a hard drive.